What to do when placing rectangular duct elbows only round sizes are visible?

Laatst gewijzigd op: 12 octobre 2023

Problem:

When placing rectangular duct elbows only round sizes are visible.

Cause:

The rectangular duct elbows are given the 'default' setting that they are round.

This is because the default setting in the Windows Registry contains an incorrect value.

Solution:

This is about Windows Registrykey's

Choose Windows -> Run.

Type REGEDIT as command.

Browse to:

HKEY_CURRENT_USER\Software\Cadac Group\Techline\Forms\DuctPart\W\STDB\Parameters\C1 -> Shape: This should be set to 1

HKEY_CURRENT_USER\Software\Cadac Group\Techline\Forms\DuctPart\W\STDB\Parameters\C2 -> Shape: This should be set to1

Close the Registry editor.

Restart Techline, the rectangular duct elbows can now again be placed as rectangular shaped elbows.

Note!!

For editing the Windows registry specific rights could be mandatory.

Cadac Group is not responsible for misuse of the Registry Editor by the user.

At Cadac, we distinguish between Sales, Service & Support. We take Sales & Service for granted. We help you purchase your product, service, training or expert and make sure you can get started without any problems. Free of charge and for nothing. You can start using your software carefree, we make sure you can get the most out of it. Are you running into technical software problems? Then you can use Cadac Support. By submitting the correct information, we can help you as quickly as possible.