Nordined and/or Techline fuctions or Doubleclick in a Viewport causes a Zoom change

Last modified on: 18 juni 2019

Problem:

With the usage of certain functions of Nordined or Techline or double-clicking in an viewport causes a zoom change.

Cause:

During these functions there is a viewchange made. This viewchange is connected to an AutoCAD Setting which automatically adds a Zoom action to the viewchang.

Deze instelling is tekening gebonden

Solution:

Enter the command: UCSFOLLOW

Set the value to 0 (Off)

After this the Zoom action wil no longer be combined with the viewchange.

At Cadac, we distinguish between Sales, Service & Support. We take Sales & Service for granted. We help you purchase your product, service, training or expert and make sure you can get started without any problems. Free of charge and for nothing. You can start using your software carefree, we make sure you can get the most out of it. Are you running into technical software problems? Then you can use Cadac Support. By submitting the correct information, we can help you as quickly as possible.